|
Hand Operated Analog Fastener
Tester
|
COM-TEN
INDUSTRIES, manufacturers of
quality physical testing products since 1960, presents the ANALOG
SERIES Roof Fastener Testers. These Hand Operated tensile testers are
used to prove the holding capacity of hundreds of types & sizes of
fasteners in roofing, construction, commercial, industrial, and other
applications.
|
|
| Specifically
engineered for pullout strength tests and nondestructive testing of
welded, staked, threaded, epoxied and power-driven fasteners. An excellent
tool for production sampling, quality control, on site testing and
verifying results during research and development of new fastening
techniques. A wide 8.25" diameter frame is designed to accommodate
lightweight fasteners up to 3.5" diameter as well as the wide range
of traditional fasteners used in the roofing industry. An optional narrow
6" diameter frame is ideal for testing in tight and confining spaces. |
Click
to view: Full Specs &
Lit
Analog
Series Tester Features:
•
8 capacities from 100 pounds to 4000 pounds with a typical power stroke of 3
inches.
•
Hydraulic rotary piston gauge cell coupled to a bourdon tube gauge providing
excellent accuracy and repeatability.
•
Grade B gauge is accurate to 2% full scale in the middle 50% of range, 3% full
scale in upper and lower 25%.
•
Calibrated & certified traceable to NIST standards and comes complete with
certificate of calibration.
•
Analog gauge has figure intervals every 10% and minor graduation at 1% in
pounds or kilograms.
•
Maximum pointer provides peak hold attained until it is reset.
•
Lightweight cast aluminum frame is extremely durable, rugged and is covered by
a lifetime guarantee.
•
Comes with locking carry case padded on the inside to protect the tester and
also provides storage for tools, etc.
•
Wide frame tests lightweight fasteners up to 3.5" dia. as well as the
wide range of traditional fasteners used.
•
An optional narrow frame is available when testing must be done up against
parapet walls or rooftop protrusions.
Certificate of
Calibration:
Each unit is tested, calibrated and
certified accurate at time of shipment to ±2% of gauge capacity when reading
the middle 50% of full scale. A Certificate of Calibration with traceability to
the National Institute of Standards & Technology is included.
1 Year Guarantee
on Analog Testers:
Com-Ten will repair or replace any
part which fails and is returned to the factory within 1 year of purchase.
Calibration, overdriving and accidental damage or abuse are not covered.
|
