Compression Cages

To use one of Com-Ten's 95 series test stand in compression, a COMPRESSION CAGE is needed. They convert these systems from tensile to compression (not needed for 700 series Universal Test Systems). Precision made of aluminum and steel, they are ideal for all of your compression testing needs. Use them with compression platens or modulus of rupture fixtures.

Sizes: various depending on model of tester

Price: inquire with our sales engineer

Normally Stocked

Compression Platens

Platens provide a smooth, flat surface to place your sample on. We offer aluminum, steel, square, round, or specialty platens for all of our testers. 

Sizes: numerous depending on model of tester

Price: inquire with our sales engineer

Normally Stocked

Standard 3-point Modulus of Rupture

These stock 3-pt flexure fixtures adjust in 1 inch increments. The lower anvils rock slightly to allow for twist in samples.

Sizes: stock to 8" span

Price: inquire with our sales engineer

Normally Stocked

MOR1161 - 4-point non-articulating Modulus of Rupture

This 4-point flex fixture is fully articulating and has anvils that rotate and rock. The upper span adjusts to 40mm and the lower span to 80mm. Anvils are 9mm diameter. Capacity is 1000 pounds.

MOR1161N - 4-point non-articulating Modulus of Rupture

This 4-point flex fixture has anvils that do not rock. The upper span adjusts to 40mm and the lower span to 80mm. Anvils are 9mm diameter. Capacity is 1000 pounds.

MORF1575 - 3-point Modulus of Rupture for ASTM F1575

Special flex fixture disgned following the ASTM F1575 to determine the bending yield moments of nails. Rolling lower anvils 1 inch wide. Adjusts lower span from 1 in to 3 in.

BBT 0405 - Ball Burst Fixture

Used to push a steel ball through a piece of fabric or textile to test its burst strength. Common in the textile industry.