Full Site Search

Adhesion testing with uplift kit

1 Dec 2008, 5:18 PM
Com-Ten is an instigator in the validation of installation of insulation membrane, with the Uplift tester, and the measurement of the bonding strength of coatings, with the Adhor tester. These products are design to proof the good installation and property of adhesion directly in the field.

Eye bolt fastener test

The 24” x 24” uplift plate is glued to the tiles. A waiting time of 24 hours is required to allow the adhesive to bond properly. The plate is grabbed by the pull tester using a female slotted adaptor which is attached to the Uplift pull tester. Then the plate is pulled off in direct tension using the hand crank of the Uplift pull tester and the corresponding pressure is applied. The gauge displays and registers the pull-out force.

Printer Friendly Tell a Friend

Your Cart
Your shopping cart is empty!


ISO9001:2008 Certified

Com-Ten Industries, for force gauge, pull tester and torque tester products

Measuring force from Apple to Zipper since 1960.
6405 49th Street North, Pinellas Park, FL 33781 • Phone: 727-520-1200 • Fax: 727-520-0299 • sales@com-ten.com
SecurityMetrics for PCI Compliance, QSA, IDS, Penetration Testing, Forensics, and Vulnerability Assessment