-
Languages
How to check crimp terminal on cables:
21 Oct 2010, 12:50 AM
| A good crimping of a terminal on a cable increases the usable life time of the connection and avoids micro cuts when using the cable in a car or an aircraft. When do you check wire terminal crimps ? During the manufacturing cycle and at each change of processing settings, including : - Checking the first batch manufactured - Check for each new setup of machines or crimping pliers (tool exchange) - Check each coil change (if terminals are supplied in a coil) - Interim checks (every 1000 crimps for example) - Check the final crimp There are 2 types of control: visual inspection and a tensile test. A / Visual control: This is to visually check that the terminal is properly positioned on the wire. The lug rings must be tightly wrapped around the cable, no strand shall be out of the crimping. The cable end must appear at the end of the terminal and should not be folded or bent. |  Wiretest 2 |
 Wiretest T1 |
B / Tensile test: This very simple test is used to verify the correct crimp pull out force. Tensile tests are performed on a motorized test machine called a 'crimpt tester ' or' terminal pull tester' that performs this tensile test. These tests are destructive.
They are performed either on pieces issued from the manufacturing process and prepared for these trials, or on samples made with wire of the same section (in the case of very long harnesses that canot been inserted on the machine.
The testing machine is equipped with a special receptacle for maintaining the terminal or utilizing a self closing grip. The cable is held by a special tool designed for not injuring the jacket. It can be a bit eccentric or self closing. Self closing grips can also be used in the case of high capacity, forces higher than 200 lbs (1000N). The testing machine generally provides tension at a constant speed of 2 inch per min until failure of the crimp or the cable. It is also possible to use manual testers for small wires. The test sample is passed if the value found is above a reference value. To define the reference value, there are general standards such as CEI760, or standards specific to certain industries (rail, aerospace, automotive). |
| The main values used are given, for guidance, in the following table : | |||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
|  Wiretest 1 | ||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||||
Average Customer Rating:
based on 1 reviews.
Write a review.
based on 1 reviews.
Write a review.
Positive Customer Review
22 Oct 2010, 6:52 AM
DKM (Guest)
Very good advice
<Incorrect crimps can also change the current carrying capability of the assembly. A proper crimp makes a near molecular bond between wire and connector.
Your Cart
Your shopping cart is empty!
Become a distributor!
Consider becoming a Com-Ten distributor today. Read the advantages of Com-Ten distributor and download our terms and conditions.
ISO9001:2008 Certified
