Software

CENTOR Manager is a simple, user-friendly utility that enables you to communicate with your CENTOR Easy, Star or Dual memory.

Pre-programmed module for COMTEST software ASTM C1161: Flexural Strength of Advanced Ceramics at Ambient Temperature

Pre-programmed module for COMTEST software ASTM C203: Breaking Load and Flexural Properties of Block-Type Thermal Insulation

Pre-programmed module for COMTEST software ASTM D1621: Compressive Properties of Rigid Cellular Plastics

Pre-programmed module for COMTEST software ASTM D1894: Static and Kinetic Coefficients of Friction of Plastic Film and Sheeting

Pre-programmed module for COMTEST software ASTM D2256: Tensile Properties of Yarns by the Single-Strand Method

Pre-programmed module for COMTEST software ASTM D4034: Resistance to Yarn Slippage at the Sewn Seam in Woven Upholstery Fabrics

Pre-programmed module for COMTEST software ASTM D6272: Flexural Properties of Un-reinforced and Reinforced Plastics and Electrical Insulating Materials by Four-point Bending

Pre-programmed module for COMTEST software ASTM D790: Standard Test Methods for Flexural Properties of Un-reinforced and Reinforced Plastics and Electrical Insulating Materials

Pre-programmed module for COMTEST software ASTM D882: Tensile Properties of Thin Plastic Sheeting

Pre-programmed module for COMTEST software ASTM F1575: Determining Bending Yield Moment of Nails

Pre-programmed module for COMTEST software ASTM F88: Seal Strength of Flexible Barrier Materials

Pre-programmed module for COMTEST software ASTM D1781: Standard Test Method for Climbing Drum Peel for Adhesives

SD memory card reader for the Centor Star and Centor Dual digital graphic force gauges. This new device makes it possible to save the values measured by the force gauge and then read them over on a computer for further processing.

Small thermal printer to record the main statistical calculations and keep a print-out of batch measurements.

Developed for the design and construction of test benches, this box uses the capabilities of Centor force gauges and torque gauges in order to ensure the safety of the equipment.

Pedal for Centor Easy, Star and Dual. This simulate a keystroke and can perform one of the following functions: Tare, Valid...

Force limit cable and pedal for Centor Easy, Star and Dual. Enables simultaneous use of the pedal and can stop a motorized test stand at a predefined set point.

Force limit cable for Centor Easy, Star and Dual. Enables stop a motorized test stand at a predefined set point.

RS232 cable for Centor First force gauge.