Compare

A very simple, economical system for checking compression springs. The measurement head gives the force applied, the displacement sensor shows the flexion or height measured under load.

Compare

A system specially designed for high precision measurements of compression. With its high reduction ratio, this manually operated test stand is well suited for the measurement of small springs with low force levels.

Compare

With its Centor Dual force gauge, fixed plate and adjustable plate, this unit can be used to test high capacity tension and compression springs. The command automatically determines the origin of the displacements and then stops the machine at a predetermined flexion value to measure the height under load.

Compare

With its Centor Dual force gauge, fixed plate and adjustable plate, this unit can be used to test high capacity tension and compression springs. The command automatically determines the origin of the displacements and then stops the machine at a predetermined flexion value to measure the height under load.

Compare

Dedicated to controls on torsion springs, this manual torsion test stand is fitted with a Centor Dual. It shows the torque and angle values on the same display. It is supplied with a set of bored plates and fitted with locating pins to hold the springs in place.