Full Site Search
Subscribe
To get our newsletter please enter your email address in the box below and press 'Subscribe' button.

I get no force indication when pulling a fastner.

The load cell attached to the gauge contains mineral oil. This load cell is sealed with lip seals or "o" rings. The seals wear out and cause an oil leak. If the oil is to low, the gauge will not indicate pull force accurately. The seals must be replaced. The assembly must be evacuated, oil filled then calibrated. Please send your load cell to Com-Ten for repair.  

Printer Friendly Tell a Friend

Article isn't rated yet. Write a review.

Your Cart
Your shopping cart is empty!