Full Site Search
Subscribe
To get our newsletter please enter your email address in the box below and press 'Subscribe' button.

CTAP software

  Previous 1 [ 2 of 2 ]  

I have lost my C-TAP operators manual.  Rate it

There is a copy of the C-TAP operators manual on your installation CD. If you require another copy please contact Com-Ten Industries.

I want to run a burst test and hold for a length of time.  Rate it

Set the force limit on the test configuration panel to the burst test limit. On the same panel select the set hold time box under hold time options. Set the amount ox time you wish to hold at force. Run the test. The tester will apply force until the force limit then stop. If you have the hold force option selected the tester will cycle on and off to maintain the force limit. If the specimen bursts before the hold time expires the test will terminate.

Every time I change the type of test in the main configure panel all parameters reset.  Rate it

This is normal operation. Instead of changing the test type on the main configure panel save each configuration under a different name. When you recall the configuration all save test parameters are reloaded.

When I print the report only shows what is on the screen.  Rate it

The print command from the file drop down menu on the analysis panel only prints what you see no the screen. To print the complete report select configure then report generator. Use the report wizard to select the report options you want.

I am getting error number 106 when starting the test.  Rate it

Check the UP/STOP/DOWN switch on the front of the tester. It must be in stop to enable the automatic functions of the tester. Set it to stop and run another test.

  Previous 1 [ 2 of 2 ]  
Your Cart
Your shopping cart is empty!